This is another ‘thing’ that I have had on my to do list (also known as a round-to-it). I first saw this on Splitcoaststampers. This is great for using scraps.
1 – sheet of 5 x 11.25″ cardstock (I trimmed down a piece of A4)
10 – pieces of patterned paper trimmed to 4.75 x 2″
1 – piece of cardstock trimmed to 7″ square
6 – 2″ square piece of patterned paper
4 – pieces of 6″ square cardstock for the boxes inside
Scoring board and the diagonal plate if you have one (note that the diagonal plate has since retired). Very sticky tape (the red sticky strip is good for this), other glue and something to crease if you haven’t got a bone folder.
Score the 5 x 11.25 piece of cardstock at the following intervals:
2.25″ – 4.5″ – 6.75″ – 9″
Crease the folds and adhere the 4.75 x 2″ papers between your score marks on the front and back.
Step 2: compartments
1. Diagonal score – on each side score at 1.5″, 3″ and 4.5″
Step 3: Folding the boxes
1. Fold opposite corners into the middle, then fold the outside edge again into the middle.
You then have to fold like below, tucking in the corners under the flap (hope that makes sense!).
Once the compartment boxes are made, I pop a piece of the 2″ square patterned paper inside to finish it off.
Step 4: the lid
The process for the lid is the same as that of the boxes, but the diagonal score marks that you do on each side are:
1.75″ – 3.5″ – 5.25″
Then fold to make the lid.
So you now have, one lid, 4 compartments and the ‘wrap’.
Step 5: the putting together bit
Stick one of the compartments on the bottom of the wrap and then space the other three compartments (as shown). I used the really sticky red strip tape for this as you need a good firm adhesive.
You can purchase Stampin’ Up! products online through my shop link at the top of the page, or here.